The ABINIT Users Mailing List ( CLOSED )

[Masayoshi Mikami <mmikami@yk.rim.or.jp>]

Hello, Good morning ("Dzien dobry"),

I just thought that you could check the following:
- the version of the ABINIT ("cut3d") you used in the analysis
- the version of the ABINIT that had produced the DEN file.

I suspect that the version of the ABINIT (cut3d) is older 
than the ABINIT that produced the DEN file.
We should have the consistency of the ABINIT versions...

If you have the source tarballs, you could type, e.g.,
  diff (v44x/Src_1managempi/hdr_io.F90) and (v43x/Src_1managempi/hdr_io.f) 
(The error message suggests this ...)

In passing, about the "header" :
http://www.abinit.org/Infos_v4.5/abinis_help.html#header

Good luck,
So long ("Do widzenia"),
Masayoshi

P.S. For some forum subscribers, please stick to Plain Text format 
(NOT HTML format). PLEASE, READ THE NETIQUETTE !!
        http://www.abinit.org/community/?text=netiquette

From: "Bohdan Andriyevsky" <bandri@tu.koszalin.pl>
Subject: [abinit-forum] cut3d does't read DEN file
Date: Sat, 2 Apr 2005 21:44:42 +0200
Message-ID: <008601c537bc$6a688060$03a56c3e@bandridom>

> Dear Abinit Users,
> I can not transform my file 'dgn_condo_DS1_DEN ' using 'cut3d.exe' (see the 
> corresponding communication below). What can be a reason?
> Thanks in advance for your reply.
> 
> Regards,
> Bohdan Andriyevsky 
> 
>   Does this file contain formatted 3D ASCII data (=0)
>    or unformatted binary header + 3D data        (=1) ?
> 1
>   1 => Your file contains unformatted binary header + 3D data
>   The information it contains should be sufficient.
>   cut3d : read file dgn_condo_ds1_den from unit number 19.
> 
>  hdr_io : ERROR -
>   The first line of the (WF, DEN or POT) file read in unit  19 is erroneous.
>   headform is       44, while it should be 23, 34, 40, 41 or 42.
>   Action : check the correctness of your file.
> 
>  leave_new : decision taken to exit ...